You configure this on your SFP Fibre connection aka Uplinks from Switch 2 Switch.ĭescription TenGigaBitEthernet Uplink 2 Main Switch This is the very last step to secure your environment. # Final step!!! After everything is working OK, you install the GUEST VLAN As Default when a client cannot authenticate. # Initial Setup for dot1x configuration (rolling out)ĭescription Configure port for NPS AuthorizationĪuthentication event server alive action reinitialize It’s authentication by MAC-ADDRESS but it’s insecure, as MAC addresses can be cloned, so you have no way of its integrity. # It does MAB authentication, but you shouldn’t be using it. The interface for a hard-coded VLAN, can also be a Designated office respectively a Office Department. The Configuration of a fast ehternet port allway’s goes without an IP Address.ĭescription Trunk port without an client (IP) but for UPLINK Vlan internal allocation policy ascending # Configured ip address of the VLAN should alway's be excluded from the DHCP Scope.Īaa authentication dot1x default group NPSRadiusĪaa authorization exec default local if-authenticatedĪaa authorization network default group NPSRadiusĪaa accounting network default start-stop group NPSRadius # Rather Remove 'mab' from the interface and make sure everyone can connect via certificates! Set Guest VLAN (at the end of the blog, because much depends on the successfull deployment, before your start stricting down). DHCP IP Helpers for the right Assignment to the DHCP Pool.
0 Comments
Leave a Reply. |